Maeda CC1485S-1, Инструкции по эксплуатации, Страница: 299 / 370

291
9. Secure the end of the wire rope (12) to the wire
socket (37) as follows:
(1) Draw the wire rope (12) through the wire socket
(37) as shown in the diagram on the right.
(2) Insert the rope wedge (41) at position (a), then
firmly pull the wire rope (12) in the direction
indicated by the arrow.
10. Attach a rope clip (4) to the wire rope (5) at the
position indicated in the diagram on the right.
11. Insert the wire socket (37) into the connection part
(a) inside the hook (10), align with the hole (b) and
insert the pin (49), then secure from both sides at
positions (c) and (d) using the bolt (50) with the
washer (51) inserted.
12. Move the operation lever to “RAISE” or “EXTEND” to
raise the hook block.
NOTES
Do not winch until the hook block has been raised;
winching before this will result in irregular winding.
CAUTION
Once the single-fall hook has been attached, wind the hook block up to the highest point
and confirm that the overwinding prevention device activates to stop the operation.