Maeda CC1485S-1, Инструкции по эксплуатации, Страница: 198 / 370

190
3.24.2 OPERATION POSTURE DURING TRAVELLING A HOISTED LOAD
• When having this machine travel with a hoisted load, take the following "Travelling hoist
posture".
•
Retract the boom to "10.5m" (three stage boom) or less.
•
Slew the boom to the front center position.
• Do not perform any operation which changes the above posture during the travelling a
hoisted load operation.
Doing so may cause the machine to tip over, resulting in serious physical injury.
When having this machine travel with a hoisted load, take the
travelling hoist posture shown in the right figure.
1. See "OPERATION 3.19 BOOM TELESCOPING
OPERATION" and retract the boom length to "10.5m"
(three stage boom) or less.
2. See "OPERATION 3.17 HOISTING AND LOWERING
OPERATION " and lower the hoisted load as near to the
ground as possible.
3. Press and hold the travelling mode selector switch on the
monitor.
The mode is set to the travelling mode and the travelling
mark is displayed on the monitor.
NOTES
• When the boom length is "10.6m" or longer, travel is
prohibited and the mode cannot be set to the travel mode.
When setting the mode to the traveling mode, set the
boom length to "10.5m" (three stage boom) or less.
• The travelling operation cannot be performed for safety
while prohibition of travelling is displayed.
• When the travelling lever is operated forward or backward,
the mode is automatically changed to the travelling mode.
However, a priority is given to the setting of the
rest/travelling mode selector switch.