Lupus Electronics XT 1 Plus, Руководство пользователя

Страница: 326 / 332

326
1.
The wireless repeater V2 needs to be active (green LED is on).
2.
Press the “learn button (sensor)”. The yellow LED lights up.
3.
Activate the learn mode of the sensor you want to add. Press the learn button of
the sensor as it is explained in the manual of the respective sensor.
4.
The repeater emits a long tone and the receiver LED briefly flashes blue. Repeat
this for all the sensors you want to add to the wireless repeater.
If a sensor has already been added to the wireless repeater V2, the repeater
sounds to brief tones.
5.
Switch off the learn mode of the wireless repeater V2 by pressing the “learn button
(sensor)” again. The mode LED is switched off.
Manual connection test between sensor and repeater:
1.
Use this function to test whether a sensor was already added to the repeater or if
the sensor is still connected to the repeater.
2.
Press the “connection test button” of the wireless repeater V2. The mode LED
flashes continuously.
3.
Press the Learn button of the sensor, which was already added to the repeater. If
the sensor was already connected, the repeater will sound a long signal and the
LED lights up for one second.
4.
After having tested the connection of all required sensors to the repeater, press
the “connection test button” again to end the test mode.
Factory settings:
1.
Make sure the neither learn mode nor connection test mode are running (mode
LED off).
2.
Press the two middle buttons of the wireless repeater V2 (“connection test” and
“learn button (sensor)”).
3.
After five seconds, you hear a long signal tone. The wireless repeater has reset.
If you hear five brief tones, the connection test or learn mode is activated. In this
case, begin the reset again beginning with step 1.
4.
The wireless repeater V2 is no longer connected to any devices (sensors, alarm
panel, other wireless repeaters).
Please note:

Each sensor that is added to the wireless repeater also needs to be added to the
alarm panel.

The distance between the alarm panel and the wireless repeater should at least
be 10 meters (10.9 yards).

If a sensor has a good connection (at least >4) to the alarm panel, we do not advise
to add it to a repeater.
Additional repeaters:
If you use more than one wireless repeater V2, please observe the following instructions: