Lupus Electronics XT 1 Plus, Руководство пользователя

Страница: 207 / 332

207
o
Alarm panel does not respond
o
Incorrect PIN code
o
Attempted to switch to home mode while the alarm panel is in arm mode
o
Forced activation of arm mode while alarm panel or sensors report an error
o
If the status check never works correctly, the keypad was not added fast
enough to the alarm panel. You need to add (click ) within 5 seconds after
the keypad was found.

Error LED:
LED flashes orange: system error, e.g.:
o
No SIM card
o
GSM not ready
o
Open tampering contact
o
Power failure
o
Sensor is out of range
o
Sensor is open
o
Battery of a sensor is low
o
Upon disarming: an alarm is still in the alarm storage

Battery :
The keypad requires a 1/2AA 3V 850mAH lithium battery. The average battery life
is two years.
If the battery is low, the orange status LED flashes
Connecting the keypad and putting it into operation
Installation of the keypad:
1.
Remove the front cover of the keypad by unscrewing the screw at the bottom.
2.
At the back cover you find two cavities. They are intended to be pierced – thus,
you can mark the locations for required drill holes for a wall installation.
3.
Use screws to install the keypad on a wall.
4.
Attach the front cover again.
Connecting the keypad to the alarm panel:
1.
Enter the installation mode of the keypad by entering the installation-PIN
(default: 0000) and pressing the * button. The power LED will light up orange.
2.
Open the web interface of the alarm panel, go to the menu “Sensors”  “Add”,
and press “Start”.
3.
Press * and then 7 on the keypad. The keypad emits a signal and will be listed
in the alarm panel.
a.
If you do not hear a signal, the alarm panel did not receive the
connection request of the keypad.
b.
If the connection request was received by the alarm panel, you will hear
three short signal sounds.
4.
Add the keypad within 5 seconds to the alarm panel by pressing next to
the keypad in the menu “Sensors”  “Add”. If you are slower when adding the
keypad, it might result in issues when you want to check the status of your
alarm panel. In that case, remove the keypad from the sensor list und add it
again.
5.
To exit the installation mode , press the disarm button two times. The