Lupus Electronics XT 1 Plus, Руководство пользователя

Страница: 242 / 332

242

This menu allows you to configure “external” sirens that are added to the alarm
panel. It is
not possible to configure the internal siren of the alarm panel in this
menu.

All settings in this menu are only transmitted and saved on the siren(s). The web
interface does not display the current setting of the sirens. After the transmission,
the alarm panel displays the setting as again.

To transmit the selected setting, select or and press “Apply now”.

The sirens will sound a notification sound to acknowledge that the new settings
have been received.

The new configuration is send to all connected sirens. If you want to set multiple
sirens differently, you need to add them later to the alarm panel or temporarily
disconnect the ones you do not want to change from their power supply.

It is not possible to display the current setting of a siren.

Tamper on/off
Deactivates the tampering contact of all currently connected “external” sirens for one
hour (useful e.g. to change the batteries).
Please note:

If the tampering contact is disabled, the siren does not transmit status updates to
the alarm panel anymore. For that time, you cannot see the current status of the
tampering contact via the menu “Sensors”
 “List”  “Sensor list”.

Attention! If you open the siren without disabling the tampering contact, the
acoustic alarm of the siren will sound – even if the siren is not connected to the
alarm panel! In this case, you should wear ear protection and disconnect the siren
as quick as possible from its power supply.

Confirmation signal on/off (with Arm / Disarm)
With this function active, the siren will sound one signal tone when arming and two
signal tones when disarming the alarm panel.
Please note:

If the tampering contact of the siren is open when arming or disarming the alarm
panel, five short acoustic signals sound even though the confirmation tone is
disabled. This can happen before the alarm panel displays an open tampering
contact, giving you the possibility to react before a tampering alarm is triggered.

Input on/off
With this function active, the external siren(s) sound confirmation signals for the
duration of the defined delay until the system is armed.
Advanced settings
Click on to change the settings of your siren. After you have selected the settings to
your preference, they are saved and the siren sounds a brief sound.
This menu is only available for the outdoor siren and small indoor siren V2 (sold since
Autumn 2018). Depending on the type of siren, this menu may look different (e.g. the
small indoor siren does not have the options to set LEDs, since this siren is not
equipped with LEDs.

All areas
If you want to assign your siren to both areas, please follow these steps:
o
Press the learn button of the outdoor siren V2. LED 1&3 light up.