Lupus Electronics XT 1 Plus, Руководство пользователя

Страница: 219 / 332

219
Lockswitch contact
Product description:
The lockswitch contact is used in combination with a
sensor input . If the contact is
opened, an alarm or an entry delay can be triggered depending on the settings.
Additionally, the alarm panel can be armed or disarmed by unlocking/locking (not
available for XT1).
Installation:
1.
At first, drill a 25 mm deep hole into the latch/batch of the dead bolt using an 8 mm
drill. If you want to route the cable of the lockswitch contact back through this hole,
you need either to use a larger drill or drill the hole in a slightly eccentric way.
2.
Two options are available to fasten the lockswitch contact:
a.
Screw the lock contact by means of the clamping flange and the supplied
(
pointed ) countersunk screws 2.9 x 13 onto wood, plastic, or metal (pre-
drill: 2 mm).
b.
Provided that the hole to support the lockswitch contact is executed as a
blind bore, the lock contact can be fixed with silicone (or similar materials)
in the hole.
3.
If the latch does not press the pin of the lockswitch contact to the acting point, you
can extend it by means of the two provided adjusting screws (2.9 x 9.5 und 2.9 x
13 –
not pointed ). Using an adjusting screw does not affect the actuating path
which is always 6 mm.
You need to fix the adjusting screw afterwards by means of a bolt adhesive (Loctite
or similar).
Note:
Do not insert the adjusting screw into the actuating pin by more than 6 mm (see
figure)!
If the lockswitch contact is to be used for sliding doors (hook bolts), you can also
install it vertically.