Lupus Electronics XT 1 Plus, Руководство пользователя

Страница: 249 / 332

249

The PIR motion detector V2 will detect motions in a range up to 12 meters (13
yards) if it is installed in a height of 2 meters (6.5 feet).

To ensure the optimal function of the PIR motion detector V2, make sure that the
PIR motion detector V2 is installed in a height of 1.8 – 2 meters (5.9 – 6.5 feet)
and that the learn button is located at the top.

Due to the detection angle (see figure above), movements at the floor are not
detected (so called “pet immune area”). However, this also allows that someone
might crawl underneath the detection area.

If you change the angle in which the PIR motion detector V2 is installed (e.g. via
the ball mount – item no. 12182), this pet immune area is removed. However, the
maximal detection range is also reduced.
Warm-up phase and rest mode:

Every time you arm the alarm panel or switch to home mode, the PIR motion
detector V2 enters a warm-up phase of approx. one minute. During this time,
detected motions will not trigger an alarm. However, detected motions will increase
the warm-up phase by an additional minute – make sure not to trigger the PIR
motion detector during the warm-up phase in order to minimise the duration of the
warm-up.

In order to save battery power, the PIR motion detector V2 enters a rest mode after
every detected motion (irrespective of the mode of the alarm panel). The rest mode
takes approx. one minute and every registered motion during the rest mode will
extend its duration.
Supervision Jumper (JP2)
Jumper deactivated (default) – supervision is active
The PIR motion detector V2 sends a signal to the alarm panel every 30-50 minutes.
Jumper active – supervision is deactivated
This settings should not be used! During the next supervision check, the alarm panel
will notify you about a supervision error of this sensor.
Sensitivity jumper (JP3)
Jumper deactivated (default)
Sensitivity is set to normal.
Jumper activated
Sensitivity is set to high – more movements are detected.
Please note:

Do not install the PIR motion detector V2 in the detection range of another sensor
(e.g. an additional motion detector with a light in front of your door).

Do not expose the PIR motion V2 detector to direct sunlight.

The PIR motion detector V2 registers movements in the temperature field. Thus, it
can also be triggered by the movements of air currents. Make sure not to install
the PIR motion detector V2 in areas where air currents with different temperatures
may cause movements (e.g. above radiators / stoves / furnaces, heated floors, air
conditioning, staircases, or behind windows).