Lupus Electronics XT 1 Plus, Руководство пользователя

Страница: 285 / 332

285
Connecting the small indoor siren and putting it into operation
1. Plug the indoor siren into a socket at the intended place of installation.
2. Only within the first three minutes after having connected it to the power grid,
can you add the mini indoor siren to the alarm panel!
3. Open the web interface of the alarm panel, go to the menu
“Sensors”  “Add”,
and press
“Start”.
4. Keep the learn button (1) of the indoor siren pressed for approx. ten seconds.
The LED lights up briefly. Release the Learn button. A connection request is
sent to the alarm panel and the LED flashes twice.
5. The alarm panel should recognize the mini indoor siren and list it in the sensor
list. If not, repeat step 3.
6. Press to add the siren to the sensor list.
7.
If you want to change the siren’s properties (name, area, zone), click on .
Range test:
1.
Open the alarm panel menu “Sensors”  “Range” and press “Start”.
2.
Press the learn button.
3.
The sensor and the signal strength should be indicated. The higher the indicated
number the better the reception (1-9).
Please note:
If the signal strength at the place of installation is below 4, we advise to use a ZigBee
repeater, since it is normal that the signal strength may fluctuate for 2-3 points, thus,
a signal loss is possible.
Rechargeable emergency battery
CAUTION:
Do not open the chassis! You risk a fatal electric shock!

The small indoor siren V2 features a rechargeable emergency battery that
will last approx. 12 hours. Thus, the small indoor siren V2 also sounds an
alarm in case of a blackout.

It takes a couple of hours to charge the emergency battery.

If you have deleted the small indoor siren and want to add it again to the
alarm panel, the emergency battery needs to be discharged (you need to
wait until the battery is empty).