Lupus Electronics XT 1 Plus, Руководство пользователя

Страница: 247 / 332

247
2.
PIR sensor
3.
Battery breaker (delivery status)
4.
Tampering contact
5.
Corner mount
6.
Battery compartment
LED:
Usually, the LED indicator does not flash. Please be aware of the following exceptions:

If the battery runs low, the LED will flash for two seconds after a movement was
detected.

If a tampering contact of the PIR motion detector is triggered (tampering
protection), the LED will flash for two seconds while transmitting the alarm signal.

If you press the test button for approx. 5 seconds, the PIR motion detector will
enter the test mode for 3 minutes. During this time, the LED will flash every time a
motion is detected. Use the test mode to adjust the PIR motion detector to suit to
your individual security requirements.
Battery:

The PIR motion detector V2 requires a 3V CR123 lithium battery. This battery will
last approx. 2.5 years at an average of 20 detected motions per day.

When the battery runs low, the PIR motion detector will transmit a notification to
the alarm panel.
Connecting the PIR motion detector V2 and putting it into operation
1.
Remove the battery breaker from the back of the PIR motion detector V2 to
energise the devise.
2.
The PIR motion detector V2 will now enter a boot process. This takes approx. 30
seconds and the LED will flash during this time. Please do not trigger the motion
detection during this period – every detected motion during the boot process will
result in an extension of the required time.
3.
Open the main menu of the alarm panel.
4.
Open the menu “Sensors”  “Add”.
5.
Click “Start”.
6.
Press the learn button of the PIR motion detector V2.
7.
The alarm panel will confirm the successful addition with a brief signal tone and
display the PIR motion detector V2 in the menu “Sensors”
 ”Add”. Click on
next to the listed sensor to finish the connection process.
Range test:
1.
Open the alarm panel menu “Sensors”  “Range” and press “Start.”
2.
Press the learn button.
3.
The sensor and the signal strength should be indicated. The higher the indicated
number the better the reception (1-9).
Please note:
If the signal strength at the place of installation is below 4, we advise to use a repeater,