Lupus Electronics XT 1 Plus, Руководство пользователя

Страница: 301 / 332

301
the housing.
2.
Insert the three supplied AAA batteries in the sensor.
3.
You can add the temperature sensor with display to the alarm panel only within
the first three minutes after having connected the temperature sensor to its
power supply!
4.
Open the menu “Sensors”  “Add” and click on “Start” in the web interface of the
alarm panel.
5.
Press the Learn button of the temperature sensor for approx. 10 seconds. When
the display light goes off, release the button briefly and press it again for about five
seconds.
6.
Add the temperature sensor via .
Range test:
1.
Open the alarm panel menu “Sensors”  “Range” and press “Start”.
2.
Press the test button.
3.
The sensor and the signal strength should be indicated. The higher the indicated
number the better the reception (1-9).
Please note:
If the signal strength at the place of installation is below 4, we advise to use a ZigBee
repeater, since it is normal that the signal strength may fluctuate for 2-3 points, thus,
a signal loss is possible.
Note:

The current temperature is displayed in the alarm panel in the menu “Sensors” 
“List”  “Status”.

In the menu “Smarthome”  “Temperature history”, you find a graphic about the
temperature of the last hour, day, and week.

The temperature sensor is not compatible with the wireless repeater and cannot
be saved in the backup file.

The signal of the temperature sensor V2 can be enhanced by a ZigBee repeater.

The operating temperature is between -10 °C and +50 °C (14F to 122F).