Lupus Electronics XT 1 Plus, Руководство пользователя

Страница: 277 / 332

277
3.
The alarm panel shows you the sensor and the corresponding signal strength.
The higher the indicated number the better the reception (1-9).
Please note:

The alarm panel regularly checks the signal strength of the sensor and shows
you the latest signal strength in the menu “Sensor”

“List”.

If the signal strength at the place of installation is below 4, we advise to use a
repeater, since it is normal that the signal strength may fluctuate for 2-3 points,
thus, a signal loss is possible.
Installation:
You can install the sensor input (9 fold) in two
ways:
1.
Using the included mount

Screw the mount to a wall.

Clip the sensor input onto the
mount (A).
2.
Use the four notches (B) to screw the
sensor input directly to a wall.

Use the notches as template for your drill holes.

Insert dowels into your drill holes

Screw the back of the sensor input onto the wall.
Factory default:
A factory default deletes all calibrated sensors from the sensor input.
1.
Remove the power supply.
2.
Press and hold the learn button.
3.
While holding the learn button pressed, reestablish the power supply.
4.
Keep the learn button pressed for another 10 seconds.
5.
The three LEDs light up.
6.
Release the learn button.
7.
The sensor input is now reset to factory default.