Lupus Electronics XT 1 Plus, Руководство пользователя

Страница: 215 / 332

215
2.
Circuit 1

Use the top part (+) to switch your lamp on and the lower part (-) to switch
your lamp off.

Briefly pressing one of the buttons activates or deactivates the power
supply for the circuit 1 (7).

If you hold the “+” button, you increase the illumination of your lamp (0%

10%

20%

…

100%).

If you hold the “-“ button, you decrease the illumination of your lamp
(100%
 90%  80%  …  0%).
3.
Circuit 2

Use the top part (+) to switch your lamp on and the lower part (-) to switch
your lamp off.

Briefly pressing one of the buttons activates or deactivates the power
supply for the circuit 2 (8).

If you hold the “+” button, you increase the illumination of your lamp (0%
 10%  20%  …  100%).

If you hold the “-“ button, you decrease the illumination of your lamp
(100%
 90%  80%  …  0%).
4.
Learn button
If you press the learn button for more than 10 seconds during the first two
minutes after the light switch V2 was connected to the power supply, the light
switch V2 resets and is deleted from the sensor list (if already added).
Additionally, a new connection request is send out.
5.
Neutral conductor
230V AC neutral conductor connector of the power supply and of your lamps.
6.
Line conductor
230V AC line conductor of the power supply.
7.
Line conductor circuit 1
230V AC line conductor of circuit 1 (e.g. lamp 1).
8.
Line conductor circuit 2
230V AC line conductor of circuit 2 (e.g. lamp 2).
Installation of light switch V2
Wiring

The cable specification for the connection is Ø 2.08-0.205 mm² or AWG 14-24.

Make sure to deactivate the fuse to prevent electric shock. Furthermore, it is
recommended to use an electric meter / gauge to verify that no current is applied.

Observe the wiring diagram as shown below to connect the light switch V2.

To connect the cables:
o
Insert a slotted screwdriver into the opening next to the cable terminal to
open the clip lock.
o
Plug in the cables.
o
Pull out the screwdriver. The clip lock closes and fixes the inserted cables.
o
Make sure that the cables are inserted securely into the clip lock and cannot
get loose.