Lenovo ThinkServer TS200 6522, Руководство по техническому обслуживанию аппаратной части

Страница: 137 / 290

Handling static-sensitive devices
Attention: Static electricity can damage the server and other electronic devices. To avoid damage, keep
static-sensitive devices in their static-protective packages until you are ready to install them.
To reduce the possibility of damage from electrostatic discharge, observe the following precautions:
v
Limit your movement. Movement can cause static electricity to build up around you.
v
The use of a grounding system is recommended. For example, wear an electrostatic-discharge wrist
strap, if one is available. Always use an electrostatic-discharge wrist strap or other grounding system
when working inside the server with the power on.
v
Handle the device carefully, holding it by its edges or its frame.
v
Do not touch solder joints, pins, or exposed circuitry.
v
Do not leave the device where others can handle and damage it.
v
While the device is still in its static-protective package, touch it to an unpainted metal part on the
outside of the server for at least 2 seconds. This drains static electricity from the package and from
your body.
v
Remove the device from its package and install it directly into the server without setting down the
device. If it is necessary to set down the device, put it back into its static-protective package. Do not
place the device on the server cover or on a metal surface.
v Take additional care when handling devices during cold weather. Heating reduces indoor humidity
and increases static electricity.
Server components
The following illustration shows the major components in the server.
1
Cover
10
SATA hard disk drive (some models)
2
Non-hot-swap power supply
11
Hot-swap hard disk drive (some models)
3
System board
12
Front adapter-support bracket
4
DIMM
13
Drive cage
5
Rear system fan
14
Hard disk drive fan assembly
6
Optical drive
15
SAS/SATA connector
Chapter 6. Replacing FRUs
129