Chapter 5 Disassembly and Assembly
5-52
10
Connect the connector (JP51) that was removed
in
11
Install the exterior frame (front) that was removed
in
•
4 screws (M4 x 8)
12
Installation Procedures (Page 5-8)"
"5.2.3 Removing/Installing the Exterior Panel
to install the insertion unit and exterior panel.
Now, you have finished with the procedures to replace the receiver motor.
5.4.8 Replacing the Lock HP Sensor
This section describes the instructions on how to replace the lock HP sensor.
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
Requirements
The works in this section can be performed using only the standard tools.
1
Removal Procedures (Page 5-6)"
"5.2.3 Removing/Installing the Exterior Panel and
to remove the second front back panel and first front panel.
2
Move the optical unit to the second front side.
If the push plate unit is not located at the
read position, then the optical unit cannot be
moved:
See
If the insertion unit has not been removed:
"5.2.6 Moving the Push Plate Unit"
to
move the push plate unit to the read position, then
move the optical unit to the second front side.
3
Remove the lock HP sensor.
Leave the pin unit assembly moved leftward, then
release the notch of the lock HP sensor to remove the
sensor from the second front back side.
4
Unplug the cable from the lock HP sensor.
•
Connector (JP45)
Caution
Be sure to turn off the power supply circuit breaker and unplug the power cable from the
equipment whenever you disassemble/assemble the equipment.
Personnel
Number
Work Hours (steps 2 to 6)
1
Second Front Side
JP45
Second Front Back Side
Pin Assembly
Caution
When removing the connector, hold a notch
on the connector without pulling a cable.
Giving a strong pull to the cable may cause
it to be broken.
Содержание 0902
