Konica Minolta 0902, Руководство по обслуживанию

Страница: 65 / 302

Chapter 3 Troubleshooting
3-11
06106 06121 06136 Transporter motor control
error (when moving to press
down position)
There was a trouble with the
motor control when the push
plate unit was moving from the
home position to the press
down position.
1. Confirm the ground. (It may cause
noise)
2. Confirm that the antistatic brush right
under the insertion slot has not fallen off.
3. Confirm following and replace the
faulty parts.
•
Ground wire of transporter unit
(if it is not broken)
•
Transporter motor
•
Motor wire:
JP52 ~ MCN6 (MDU)
•
MDU
06107 06122 06137 Transporter read sensor error
(when moving to read
position 2)
Transporter read sensor did not
go ON when the push plate unit
was moving from the press down
position to the read position.
1. Confirm that there are no foreign
objects between the push plate and
the frame, and remove if there are any.
2. Confirm if there is enough grease on
the drive shaft, nut, or transporter
motor unit, and apply grease if it is not
enough.
3. Confirm following and replace the
faulty parts.
•
Transporter read sensor
•
Sensor wire:
JP47 ~ MCN4 (MDU)
•
Transporter motor
•
Motor wire:
JP52 ~ MCN6 (MDU)
•
MDU
06108 06123 06138 Transporter motor control
error (when moving to read
position 2)
There was a trouble with the
motor control when the push plate
unit was moving from the press
down position to the read position.
1. Confirm the ground. (It may cause
noise)
2. Confirm that the antistatic brush right
under the insertion slot has not fallen off.
3. Confirm following and replace the
faulty parts.
•
Ground wire of transporter unit
(if it is not broken)
•
Transporter motor
•
Motor wire:
JP52 ~ MCN6 (MDU)
•
MDU
Error code Description of the error Response
(References to replacement methods are
listed at the end of the table.)
S E I