Chapter 2 Before the Repair
2-27
2.6.3 Initialization Action
Initialization action will be performed according to the timing of each status transition.
Description of initialization action per initialization operation timing
Initialization of the FPGA
•
Transmit the program in FPGA at the startup.
Set the Parameters of the FPGA
•
Set the gain offset value, drive pattern of the motors, factory setting of the shading compensation,
and factory setting of the QRV table to the FPGA.
Initialization and Operation Check of the Mechanical Unit
•
Check if there is cassette inside the equipment and close the shutter.
•
Move the unit to the initial position.
•
Shutter: Closed
•
Receiver: Receiver
home
position
•
Justifier guide:
Justifier home position
•
Push plate unit:
Transporter home position
•
Subscan unit:
Subscan home position
•
Perform warm-up action and operation check of all units.
(Warm-up action: Operate in a maximum operable range)
Initialization timing
Initialization action
After power on
Initialization and Operation Check of the
Set the Parameters of the FPGA"
Transition from the stopped to the routine mode
Initialization and Operation Check of the
Set the Parameters of the FPGA"
Transition from the sleep mode to the routine
mode
Initialization and Operation Check of the
Set the Parameters of the FPGA"
From the sleep mode to the maintenance mode
Initialization and Operation Check of the
Transition from the maintenance mode to the
routine mode
Initialization of the Mechanical Unit"
Transition after detecting the
close of the second front door to the routine
mode
Initialization of the Mechanical Unit"
Transition after detecting the
close of the second front door to the
maintenance mode
Содержание 0902
