Konica Minolta 0902, Руководство по обслуживанию

Страница: 63 / 302

Chapter 3 Troubleshooting
3-9
3.2.3 06100 ~ 06143: Transporter Motor Errors
•
Error codes S column: Errors at the read operation/calibration.
•
Error codes E column: Errors during erase operation.
•
Error codes I column: Errors during initialization.
Error code Description of the error Response
(References to replacement methods are
listed at the end of the table.)
S E I
06100 06115 06130 Transporter read sensor error
(when moving to read
position)
Transporter read sensor did not
go ON when the push plate unit
was moving to the read position.
1. Confirm that there are no foreign
objects between the push plate and
the frame, and remove if there are any.
2. Confirm if there is enough grease on
the drive shaft, nut, or transporter
motor unit, and apply grease if it is not
enough.
3. Confirm following and replace the
faulty parts.
•
Tumbler
(if the spring is not broken)
•
Transporter read sensor
•
Sensor wire:
JP47 ~ MCN4 (MDU)
•
Transporter motor
•
Motor wire:
JP52 ~ MCN6 (MDU)
•
MDU
06101 06116 06131 Transporter motor control
error (when moving to read
position)
There was a trouble with the
motor control when the push
plate unit was moving to the
read position.
1. Confirm the ground. (It may cause
noise)
2. Confirm that the antistatic brush right
under the insertion slot has not fallen off.
3. Confirm following and replace the
faulty parts.
•
Ground wire of transporter unit
(if it is not broken)
•
Transporter motor
•
Motor wire:
JP52 ~ MCN6 (MDU)
•
MDU
06102 06117 06132 Transporter read sensor error
(when moving to HP)
Transporter read sensor did not
go OFF when the push plate
unit was moving to the home
position.
1. Confirm that there are no foreign
objects between the push plate and
the frame, and remove if there are any.
2. Confirm if there is enough grease on
the drive shaft, nut, or transporter
motor unit, and apply grease if it is not
enough.
3. Confirm following and replace the
faulty parts.
•
Transporter read sensor
•
Sensor wire:
JP47 ~ MCN4 (MDU)
•
Transporter motor
•
Motor wire:
JP52 ~ MCN6 (MDU)
•
MDU