Chapter 3 Troubleshooting
3-28
References for response method
•
See
for the position of the CIU.
•
See
"5.10.3 Replacing the CF Card (Page 5-118)"
for the procedure to replace the CF card.
•
See
"5.10.1 Replacing the CIU (Page 5-115)"
for the procedure to replace the CIU.
3.2.18 26000 ~ 26900: Operation Errors
25000
Network error
−
Non-timeout
Network control program has
detected a problem in the system
call related to the network I/F.
Confirm in following order:
1. Confirm if the console in communication is operating
normally.
2. Confirm that there is no malfunction of the network hub
between the equipment and the console, power
outage, or disconnection of the Ethernet cable.
3. Confirm the network setup on the console, reader, and
JM (see Install/Maintenance Manual for the console).
4. Replace only the CIU and confirm the operation.
5. Replace both CIU and CF card, restore the circuit data,
and confirm the operation.
25100
Network error
−
Timeout (during normal
communication)
Data transmission to the
console, mainly during
operation of the maintenance
mode, has timed out.
25200
Network error
−
Timeout (during image
transfer)
Image transmission to the
console, mainly during the
image read operation in routine
mode, has timed out.
Error
code
Description of the error
Response
(References to replacement methods are listed at the end
of the table.)
26000
Operation error
−
Invalid job
There was an unsupported command
in the job searched from JM.
(This error is displayed on the
console only)
Install the most current reader firm and console application
with matching versions.
26010
Operation error
−
Invalid job parameter
The job searched from JM
included a command parameter
that is not compatible.
(This error is displayed on the
console only)
26100
Operation error
−
Out of mode job
The job searched from the JM was
not executable with any of the
operation mode of the equipment.
(This error is displayed on the
console only)
If this error occurred on the startup after powering OFF the
reader while it was sleeping, it should operate without any
problem.
In any other cases, confirm that the settings of the JM are
correct (see Install/Maintenance Manual for the console).
26200
Operation error
−
Invalid console
During the maintenance mode,
there was an operation request
from a console that is not
performing the maintenance.
(This error is displayed on the
console only)
It will operate without any problems.
When the reader is under maintenance, it will not accept
the operation request from other consoles.
Error
code
Description of the error
Response
(References to replacement methods are listed at the end
of the table.)
Содержание 0902
