Kongsberg Simrad SN90, Руководство по установке

Страница: 105 / 298

381298/C
103
(CD010205_303_010)
A
Sealing plate
Note the direction!
The cables with the
cable gland kit (packing
nut, rubber gasket and
washers) shall be inserted
from below (the "wet
side").
B Air vent
This air vent is only used
if you place the sealing
plate on top of a trunk.
Use it to release air from the trunk.
C
Packing nut
D
Rubber gasket
E Washers
WARNING
Verify that all welding has been finished before the transducer cables are pulled
through the sealing plate. Once the cables have been installed, any welding on
the sealing plate and/or the steel conduit may damage the cables beyond repair.
Procedure
1 Verify that the sealing plate and the steel conduit (if relevant) has been finished,
and that all welding has been finalized.
2 Lower the fish tape (wire pulling tool) down from the top of the steel conduit (if
applicable), and through the sealing plate.
3 Verify that the rubber gasket, washers and packing nut are threaded onto the
transducer cables, and they these are kept between the sealing plate and the
transducer.
The rubber gaskets, washers and packing nuts are provided with the transducer.
Upon delivery, they are threaded onto the cable and fastened, normally with wire
wraps.
4 Fasten the end of the fish tape to the transducer cables using electrician’s tape.
5 Pull thetransducer cables through the holes in the sealing plate.
Note
Be careful, so that you do not damage the connectors that are mounted to the cables.
Installing the transducer