Kongsberg Simrad SN90, Руководство по установке

Страница: 269 / 298

381298/C
267
If a unit needs temperature protection, the box to be used for storage and transportation
must be lined on all walls, base and lid, using minimum 5 cm thick polyurethane or
polystyrene foam.
Most system units can normally be stored in temperatures between -30° C and +70° C.
Refer to the relevant technical specifications for details.
Note
Unless otherwise specified, transducers and hydrophones must not be stored in
temperatures below −10°C and above +50°C.
Procedure
1 Clean and protect the unit as described in the relevant procedures.
2 Place the unit in a suitable cardboard box or wooden crate.
3 Make sure that the unit is well be protected against physical damage by means of
shock-absorbing insulation mats.
4 Take the necessary precautions if the unit must be protected against high or low
temperatures, and mark the box accordingly.
5 Mark the box clearly to identify its contents.
6 Stored the box in a dry and dust-free area.
Related topics
Transporting Kongsberg Maritime equipment, page 256
Lifting units and transportation boxes, page 257
Circuit board unpacking and handling, page 270
Returning a printed circuit board or an electronic module to Kongsberg Maritime,
page 272
About Electrostatic Discharge (ESD), page 273
Storage after use
If a unit is removed from its operating location and placed into storage, it must be
properly cleaned and prepared before packing.
Topics
Cleaning an electronic cabinet or unit, page 268
Cleaning a mechanical or electromechanical unit, page 269
Equipment handling