Kongsberg Simrad SN90, Руководство по установке

Страница: 207 / 298

381298/C
205
3 On the
Setup
menu, click
Installation
.
Observe that the
Installation
dialog box opens. This dialog box contains a number
of pages selected by the menu on the left side.
4 On the left side of the
Installation
dialog box, click
I/O Setup
.
Observe that the
I/O Setup
page is shown.
5 Select the interface port you wish to use.
a Observe that a list of the Processor Unit’s serial and network interface ports
is shown.
b Click once on the port you wish to use (serial or LAN).
c Click the
Input
button below the list to open the
Select Inputs
dialog box.
6 On the
Available Inputs
list, click the system/data type(s) you wish to import, then
click [
►
].
To import navigation data, choose
GPS
,
DistanceLog
,
SpeedLog
and/or
Gyro
.
7 Verify that the chosen data type(s) are shown in the
Inputs
list.
8 Click OK to save the chosen parameters and close the
Select Inputs
dialog box.
9 On the
I/O Setup
page, click once on the chosen communication port to select it.
10 If you are using a serial port, define the relevant communication parameters.
a Click
Setup
to open the
Serial Port Setup
dialog box.
b In the
Serial Port Setup
dialog box, define the relevant parameters for the
communication.
The communication parameters defined for
NMEA 0183
are:
•
Baud rate
: 4800 bits per second
•
Data bits
: 8
•
Parity
: None
•
Stop bits
: One
Some instruments may offer other parameters and/or choices. You must always
check the relevant documentation provided by the manufacturer.
c Click
OK
to save the chosen parameters and close the
Serial Port Setup
dialog
box.
11 If you are using an Ethernet communication port (LAN), define the relevant
communication parameters.
a Click
Setup
to open the
LAN Port Setup
dialog box.
b In the
LAN Port Setup
dialog box, define the relevant parameters for the
communication.
The parameters must be set up to match your network environment.
Setting to work