Komatsu PC45MR-30403, Руководство по эксплуатации и обслуживанию

Страница: 47 / 475

PRECAUTIONS FOR TRANSPORTATION
When the machine is transported on a trailer, serious personal injury or death may result because of the acci-
dent during transportation. Always observe the following.
• Always check the machine dimensions carefully. Depending on the work equipment and optional devices
installed, the machine weight, transportation height, and overall length differ.
• Check beforehand that all bridges and other structures on the transportation route are strong enough to
withstand the combined weight of the transporter and the machine being transported.
• This machine may need to be divided into components for transportation depending on the regulation.
When transporting the machine, consult your Komatsu distributor.
PRECAUTIONS WHEN LOADING AND UNLOADING
If handling is improper when loading or unloading the machine, it is dangerous that the machine may tip over or
fall. It requires particular attention. Always observe the following.
• Perform loading and unloading on a firm, level ground only. Avoid road edge or place near the cliff.
• Never use the work equipment to load or unload the machine. There is danger that the machine may fall or
tip over.
• Always use ramps of adequate strength. Be sure that the
ramps are wide, long, and thick enough to provide a safe
loading slope. Take suitable steps to prevent the ramps
from moving out of position or coming off.
(1) Chocks
(2) Ramp
(3) Ramp width
(4) Angle of ramp: Max. 15 °
(5) Block
• Be sure the ramp surface and the platform of trailer are
clean and free of grease, oil, ice, water and other loose materials. If any, remove them. Remove dirt around
the undercarriage of the machine. On a rainy day, in particular, be extremely careful since the ramp surface
is slippery.
• Run the engine at low idle and drive the machine slowly at low speed.
• When on the ramps, do not operate any lever except for the travel lever (travel forward and reverse).
• Never correct your steering on the ramps. If necessary, drive off the ramps onto the ground, correct the di-
rection, then enter the ramps again.
• The center of gravity of the machine will change suddenly at the joint between the ramps and the loading
platform, and there is danger of the machine losing its balance. Drive slowly over this point.
• When loading or unloading to an embankment or platform, make sure that it has suitable width, strength,
and grade.
• When swinging the upper structure on the loading platform, lower the work equipment, retract it, and per-
form the operation slowly.
• For machines equipped with a cab, always lock the door after loading the machine. To prevent the door
from opening during transportation.
• When the handrail is required to be removed, be careful not to lose it.
When reinstalling the handrail, be sure to install it securely.
PRECAUTIONS FOR OPERATION SAFETY
2-36