Komatsu PC45MR-30403, Руководство по эксплуатации и обслуживанию

Страница: 348 / 475

METHOD FOR CHECKING AND ADJUSTING STEEL SHOES AND ROADLINERS
TRACK TENSION
The wear of the pins and bushings of the undercarriage depends on the working condition and soil condition.
Check the track tension occasionally and keep it in the standard range.
Perform check and adjustment on a level and firm ground.
METHOD FOR CHECKING STEEL SHOES AND ROADLINERS TRACK TENSION
1.
Run the engine at low idle, then move the machine forward for a distance equal to the track length on
ground, and slowly stop the machine.
2.
Place wooden block (3) which reaches from idler (1) to
carrier roller (2) on the track.
3.
Measure maximum deflection (a) between the under sur-
face of the wooden block and top surface of the track.
If deflection (a) is in the standard range (10 to 30 mm {0.4
to 1.2 in} ), the track tension is correct.
If the deflection is out of the standard range, adjust it into the standard range.
METHOD FOR INCREASING STEEL SHOES AND ROADLINERS TRACK TEN-
SION
Items to be prepared
Grease pump
1.
Pump in grease through grease fitting (4) by using a
grease pump.
Grease can be pumped in until distance (S) from the idler
support to the track frame becomes 0 mm {0 in} . If the
track tension is still loose, the pins and bushings are ex-
cessively worn.
Ask your Komatsu distributor to turn the bushing 180° or
replace it.
2.
To check if the tension is correct, run the engine at low
idle, and move the machine slowly forward by an amount
equal to the length of track on ground.
3.
Check the track tension again, and if the tension is not cor-
rect, adjust it again.
MAINTENANCE MAINTENANCE PROCEDURE
4-39