Page 25
Garden Building
Installation Guide
Product Code : TGBv6.1 / November 2011
Select the window to fit against the
previously installed window.
It is imperative
that the
drain slots in every window are
located at the bottom of the window and
facing front as shown below.
Please also note that two sill support
blocks (C106) are attached to the bottom
of the windows also shown below.
Before installation commences check each
window for any defects such as scratches or
bowing. If you find any defects please follow
the complaints procedure highlighted at the
front of this manual.
You will notice that each window corner has
the inner legs on the window detail notched
away. It is imperative that this detail is
present to ensure that all 18mm inline
couplings (A104) can slide into position.
The notch detail is highlighted at the top of
the next column.
Please note: Any slight bow in the
windows will be corrected as the window
connectors are slid into position.
Fitting the Intermediate Window
Check that the 150mm sill (P106) is clear of
dust or dirt then line up the sill support
blocks (C106) with the milled out sections at
the end of the 150mm sill (P106).
Position the window onto the 150mm sill
(P106) and slide towards the first window.
Prior to the positioning of the window into its
final place, apply a bead of silicone to the
top of the 150mm sill (P106) and inline with
the rear face of the 150mm sill (P106).
