Page 61
Garden Building
Installation Guide
Product Code : TGBv6.1 / November 2011
Check that the double door outer frame is
square, plumb and not in twist (check that
the diagonal measurement from corner to
corner is equal in both directions).
Two or three sash hinges will be fitted to the
door leafs with all relevant components,
except for the sash hinge adjustment cover
cap.
Two or three outer frame hinges and sash
hinge adjusters are pre-fitted to the door
outer frame. The hinge pin, hinge pin cover
cap and hinge pin grub screw are supplied
seperately.
To hang the door, lift and slide the door sash
assembly to allow the sash hinge adjuster to
slide in between the outer frame hinge.
Once in position, pass the hinge pins
through both hinge parts. It may be
necessary to tap each pin down using a
mallet. Do not fit the outer hinge cover and
sash hinge cover caps at this time as some
adjustment may be required later.
Ensure that the slot mark in the hinge pin
points away from the door sash.
To prevent the hinge pins from turning, it is
recommended that the hinge pin grub
screws are fitted at this point. To do this,
