Page 39
Garden Building
Installation Guide
Product Code : TGBv6.1 / November 2011
Once the boss end (C9170) is in position,
locate the separate bolt through the
predrilled hole in the underside of the
universal ridge wing ensuring that the bolt
passes through the hole in the boss end.
Permanently fix in place by use of a M5
flange nut.
Start the ridge assembly by attaching the
Georgian hip bars to the boss end (C9170).
These are the glazing bars which run
diagonally from the corners of the eaves
beam (A5080) to the mini boss ends
(C9170).
Temporarily support the ridge assembly in
the correct position. Slot the holes at the
bottom of the Georgian hip bar over the M5
x 25mm bolts located in the single bolt
retainers that sit either side of the eaves
beam corner.
Now locate a double bolt retainer from
underneath the boss end and through the
holes.
Slot the top of the Georgian hip bar over the
double bolt retainer and loosely attach the
M5 flange nut, but do not fully tighten at this
stage. Repeat for the Georgian hips on the
opposite ridge wing.
Once the rear Georgian hip bars are in
position, fit the front ones.
Once completed, with the four Georgian hip
bars in position, the ridge is self supported
and additional roof checks to ensure the
build is plumb and level should be carried
out.