Page 38
Garden Building
Installation Guide
Product Code : TGBv6.1 / November 2011
Referring to your roof plan, select the correct
number of bolt retainers (C9144) complete
with M5 x 25mm bolts (C9142) and slide into
the channels of the universal ridge wings
(A5081).
To identify the glazing bar positions for your
conservatory, refer to your roof plan, where
the first glazing bar (marked as P1) is
always located at the top left of the diagram.
The glazing bars can then be counted anti-
clockwise around the layout. Please note: all
glazing bars must be counted in sequence.
These will then correspond to the numbering
on the glazing bar assemblies.
It will be easier to assemble the glazing bars
if all the M5 flange nuts are removed from
the double bolt retainers in the eaves beam
and the universal ridge wings, and kept
about your person for use as and when you
require them.
Select the mini boss end (C9170) for
attachment to the universal ridge wings
(A5081).
It is easier if both the mini boss ends
(C9170) are assembled to the ridge before
you lift the ridge assembly into position for
installation.
The mini boss ends are connected to the
universal ridge wings by use of a single bolt
retainer and a separate single bolt attached
to each universal ridge wing.
Connecting Boss Ends
Select a single bolt retainer and a separate
bolt without the retainer as shown.
Slide a single bolt retainer into both of the
universal ridge wings.
Locate the mini boss end (C9170) over the
single bolt retainer located in both of the
universal ridge wings.
