Juniper JUNOSE 11.0.X MULTICAST ROUTING, Руководство по настройке

Страница: 663 / 788

interface atm
Use to configure an ATM interface or subinterface type in the slot / port . subinterface
format:
■
■
slot —Specifies router chassis slot
■
port —Specifies I/O module port
■
subinterface —Specifies subinterface number
■
Example
host1(config-if)# interface atm 9/1.1
■
Use the no version to remove the ATM interface or subinterface.
■
See interface atm
interface fastEthernet
■
Use to select a Fast Ethernet (FE) interface on a line module or an SRP module.
■
Example
host1(config)# interface fastEthernet 1/0
■
Use the no version to remove IP from an interface or subinterface. You must
issue the no version from the highest level down; you cannot remove an interface
or a subinterface if the one above it still exists.
■
See interface fastEthernet
interface gigabitEthernet
■
Use to select a Gigabit Ethernet interface.
NOTE: You can configure only the primary port, 0, on the Gigabit Ethernet module.
The router automatically uses the redundant port if the primary port fails.
■
Example
host1(config)# interface gigabitEthernet 1/0
■
Use the no version to remove IP from an interface. You must issue the no version
from the highest level down; you cannot remove an interface or a subinterface
if the one above it still exists.
■
See interface gigabitEthernet
interface tenGigabitEthernet
■
Use to select a 10-Gigabit Ethernet interface on the E120 router or the E320
router.
■
Use the slot/adapter/port format.
Configuring Dynamic Subscriber Interfaces
■ 623
Chapter 25: Configuring Subscriber Interfaces