Juniper JUNOSE 11.0.X MULTICAST ROUTING, Руководство по настройке

Страница: 644 / 788

■
See ERX Module Guide, Table 1, ERX Module Combinations for detailed module
specifications.
■
See ERX Module Guide, Appendix A, Module Protocol Support for information about
the modules that support subscriber interfaces.
For information about modules that support subscriber interfaces on the E120 and
E320 Broadband Services Routers:
■
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
■
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support subscriber interfaces.
Interface Specifiers
The configuration task examples in this chapter use the slot / port format to specify
an interface. However, the interface specifier format that you use depends on the
router that you are using.
For ERX7xx models, ERX14xx models, and ERX310 routers, use the slot / port format.
For example, the following command specifies a Gigabit Ethernet interface on slot
0, port 1 of an ERX7xx model, ERX14xx model, or ERX310 Broadband Services
Router.
host1(config)# interface gigabitEthernet 0/1
For E120 and E320 Routers, use the slot / adapter / port format, which includes an
identifier for the bay in which the I/O adapter (IOA) resides. In the software, adapter
0 identifies the right IOA bay (E120 router) and the upper IOA bay (E320 router);
adapter 1 identifies the left IOA bay (E120 router) and the lower IOA bay (E320
router). For example, the following command specifies a Gigabit Ethernet interface
on slot 5, adapter 0, port 0 of an E320 router.
host1(config)# interface gigabitEthernet 5/0/0
For more information about supported interface types and specifiers on E Series
routers, seeInterface Types and Specifiers in
JUNOSe Command Reference Guide .
Subscriber Interfaces References
For more information about the DHCP local server and DHCP external server, which
are used in dynamic creation of subscriber interfaces, consult the following resources:
■
“DHCP Overview Information” on page 455
■
RFC 2131—Dynamic Host Configuration Protocol (March 1997)
Dynamic Creation of Subscriber Interfaces
As an alternative to creating static subscriber interfaces, you can configure E Series
routers to create subscriber interfaces dynamically.
604 ■
Subscriber Interfaces References
JUNOSe 11.0.x Broadband Access Configuration Guide