Juniper JUNOSE 11.0.X MULTICAST ROUTING, Руководство по настройке

Страница: 470 / 788

Data rx 68383456 68383456 0 0
Data tx 68383456 68383456 0 0
Meaning
Table 84 on page 430 lists the show l2tp destination command output fields.
Table 84: show l2tp destination Output Fields
Field Description Field Name
Configured status of the destination Configuration
Administrative status of the destination:
■
enabled—No restrictions on creation and
operation of sessions and tunnels for this
destination
■
disabled—Router disabled existing sessions and
tunnels and will not create new sessions or
tunnels for this destination
■
drain—Router will not create new sessions or
tunnels for this destination
Administrative state
Whether or not the router sends traps to SNMP for
operational state changes SNMP traps
Address information for the specified destination Destination address
Method used to transfer traffic Transport
Name of the virtual router on which the tunnel is
configured Virtual
Addresses of the local and remote interfaces Local and peer addresses
Effective administrative state—The more restrictive
of the router and destination administrative states.
This setting, rather than the administrative state of
the destination, determines whether the router can
create new sessions or tunnels and whether the
sessions or tunnels are disabled for this destination. Destination status
Sub-interface information about the L2TP destination Sub-interfaces
Number of sessions or tunnels that the router created
for this destination total
Number of operational sessions or tunnels for this
destination active
Number of requests that did not reach an operational
state for this destination failed
Number of requests that failed because the tunnel
password was invalid for this destination auth-errors
Information about the traffic sent and received Statistics
430 ■
Monitoring Detailed Configuration Information for Specified Destinations
JUNOSe 11.0.x Broadband Access Configuration Guide