John Bean B 200, Руководство оператора

Страница: 36 / 128

36
1
5-3
I
O
4-4
Operation
5.2 Preparation
•
The operator should be familiar with the warnings
and cautions.
•
The operator should be qualifi ed to work with the
machine.
•
Alwaysensure that the wheel guard is lifted and the
gauge arm is in its home position (fully retracted).
5.2.1 Power up
•
Do not keep any key pressed during power up.
Refer to ( Fig. 5-3 ).
•
Insert the power cable plug in the mains socket “ 1 ”.
•
Set the start switch to the “ I ” position.
Note : If the unit beeps and does not proceed or
if an error code is shown, refer to Chapter
(
F
7 ).
The unit will beep and perform a self-test now.
After switch on the fi rst screen page shown is
RIM
DATA ENTRY
( Fig. 4-4 ).
The unit is now ready for commands.
5.2.2 Status at switching on
The electronics is factory programmed so that upon
machine start-up the following operating modes are
pre-set:
–
vehicle type 1 (car wheel with nominal
dimensions in inches, width 6.5” and diameter
15.0”)
– entry of rim data in inches
– display of amount of unbalance in 5 g increments
– suppression of minor unbalances (limit set to:
3.5 g)
– automatic braking of wheel when guard is
opened during the measuring run
– compensation of adaptor unbalance switched
off
– Starting the measuring run by closing the wheel
guard.
..