DIGISPENSE 3009 CONTROLLER MODULE, STYLE B
Page 3-4
29 October, 2019
IVEK Corp. P03R017E
3.1.1.3 Start Push-button (Figure 3.1 Item 3)
This push-button begins the pumping operation. The LED above the push-button illuminates when the pump is operating.
3.1.1.4 Active Indicator (Figure 3.1 Item 4)
The Active Indicator illuminates when the pump is operating and blinks when a fault occurs.
3.1.1.5 Stop Push-button (Figure 3.1 Item 5)
This push-button stops the pumping operation. The LED above the push-button illuminates when the pump is stopped.
3.1.1.6 Idle Indicator (Figure 3.1 Item 6)
The Idle Indicator illuminates when the pump is stopped.
3.1.1.7 Arrow Push-buttons (Figure 3.1 Item 7)
The Arrow Push-buttons move the cursor on the display and are used to change values.
3.1.1.8 Enter Push-button (Figure 3.1 Item 8)
The Enter Push-button has two functions; the first function selects a value to change that has been highlighted using
the arrow push-buttons, the second function stores the changed value in the Controller Module.
3.1.2 Rear Panel Detail (Figure 3.2)
The rear panel contains the interface connections for controlling the system. The following components are located on
the rear panel.
1. Power Entry Module
2. Fan
3. MOTOR Connector
4. AUX1 AUX2 Connector
5. CC TRIGGERS Connector
6. USB Connector
7. RS232 Connector
8. RS485 Connector
9. LOGIC I/O Connector
3.1.2.1 Power Entry Module (Figure 3.2 Item 1)
The power entry module contains a receptacle for a standard IEC power cord, an On (1) Off (0) switch, fuse holder
and fuses.
The design of the power entry module requires the line cord be disconnected before the fuse holder is removed. Refer
to the Title Page section of your manual for fuse information.
3.1.2.2 Fan (Figure 3.2 Item 2)
The fan keeps the devices in the Controller Module from getting too hot. Make sure the area around the fan is clear of
obstructions.