IBM xSeries 236 8841, Руководство пользователя

Страница: 121 / 210

Note: See “System replaceable units” on page 144 to determine which components should be replaced by a field
service technician.
Error code/symptom FRU/action
1301
(I
2
C cable to front panel not found)
1. Verify operator information panel cable is connected to J40 on
system board.
2. Cable.
3. Front panel
4. Power switch assembly
5. System board
1302
(I
2
C cable from system board to power on
and reset switches not found)
1. Verify power on and reset switch cable is connected to J42 on
system board.
2. Cable.
3. Power switch assembly
4. System board
1303
(I
2
C cable from system board to power
backplane not found)
1. Cable
2. Power cage assembly, if installed
3. System board
1304
(I
2
C cable to diagnostic LED board not
found)
1. Verify light path diagnostics panel cable is connected to J36 on
system board.
2. Power switch assembly.
3. System board.
1600
(The system management processor is not
functioning) Do the following before
replacing a FRU:
1. Ensure that BMC reset switch is in the
OFF position.
2. Remove the ac power to the server,
wait 20 seconds; then, reconnect the
ac power. Wait 30 seconds; then, turn
on the server.
v System board
1601
(The system is able to communicate to the
system management processor, but the
system management processor failed to
respond at the start of POST.) Do the
following before replacing a FRU:
1. Remove the ac power to the server,
wait 20 seconds; then, reconnect the
ac power. Wait 30 seconds; then, turn
on the server.
2. Flash update the system management
processor.
1. Remote Supervisor Adapter, if installed
2. System board
1602
(Optional service processor not properly
installed.)
Disconnect all server and option power cords from server, wait 30
seconds, reconnect, and retry.
Chapter 6. Symptom-to-FRU index
111