IBM xSeries 236 8841, Руководство пользователя

Страница: 71 / 210

Diagnostics panel card
Complete the following steps to remove the diagnostics panel card.
Note:
v
Read “Installation guidelines” on page 11.
v
Read Appendix B, “Safety information,” on page 153.
v
Read “Handling static-sensitive devices” on page 12.
1. Turn off the server.
2. Disconnect all external cables and power cords from the back of the server.
3. Remove the server cover (see “Removing the left-side cover” on page 14).
4. Disconnect and remove adapters and spacers (see “Installing or replacing an
adapter” on page 25).
5. Remove the two center fans (see “Replacing a center fan (3 or 4)” on page 19).
6. Remove the plastic baffle.
7. Disconnect the diagnostics panel card cable from the system board (J36).
Note: The illustrations in this publication might differ slightly from your
hardware.
8. Grasp the tab on the diagnostics panel card and gently pull up and to the right
until the card assembly releases.
To replace the diagnostics panel card, line up the two notches on the left and snap
the assembly into place; then, connect the cable to the system board.
Chapter 4. Service replaceable units
61