IBM xSeries 236 8841, Руководство пользователя

Страница: 73 / 210

Diskette drive
Complete the following steps to remove the diskette drive.
Note:
v
Read “Installation guidelines” on page 11.
v
Read Appendix B, “Safety information,” on page 153.
v
Read “Handling static-sensitive devices” on page 12.
1. Turn off the server and all attached devices.
2. Disconnect all external cables and power cords from the back of the server.
3. Remove the server cover (see “Removing the left-side cover” on page 14).
4. Remove the front bezel (see “Removing the bezel” on page 16).
5. Press in on the two blue diskette drive release tabs until the drive is released
from the chassis.
6. Carefully pull the drive away from the chassis until the cables at the rear of the
drive are accessible.
7. Remove the two cables from the back of the drive and pull the drive out.
To replace the diskette drive, reverse the previous steps.
Note: If you are replacing the drive, prepare the new drive for the server with the
following procedure:
1. Remove the side rails from the drive by gently pulling them away from
the drive until they detach.
2. Insert one pin of the rail into the notch near the rear of the drive.
3. Pushing the rail gently toward the rear of the drive, insert the other pin
into the notch near the front of the drive.
4. Press in on the metal strip in the rail to secure the rail to the drive.
Chapter 4. Service replaceable units
63