IBM xSeries 236 8841, Руководство пользователя

Страница: 81 / 210

Complete the following steps to remove the adapter-support bracket as a single
unit:
1. Disconnect any cables that are connected to the full-length adapters.
2. Lift the adapter-retention clip on top of the adapter-support bracket (for the
location of this clip, see the illustration at “Installing or replacing a hot-plug
adapter (slot 6)” on page 28; then, remove the full-length adapters and plastic
dividers.
3. Remove the adapter-support bracket.
a. Press the release tab on each end of the adapter-support bracket. There are
two latches; one at each end of the adapter-support bracket.
b. Slide the adapter-support bracket out of the guides; then, remove it from the
server.
Note: To reinstall the adapter-support bracket and other components that you
removed or disconnected, reverse the preceding steps. Remember to
reroute the cables that you disconnected and to reconnect the center-fan
cable to the system board (see “System-board internal connectors” on
page 78).
Chapter 4. Service replaceable units
71