IBM Eserver xSeries 360 Type 8686, Руководство пользователя

Страница: 88 / 184

74
IBM® xSeries 360: User’s Reference
1. Review the safety precautions beginning on page 53, and “Handling static-
sensitive devices” on page 52.
2. Remove the bezel (see “Removing the server top cover and bezel” on page 66).
3. Remove the filler panel from one of the empty hot-swap bays by inserting your
finger into the depression at the left side of the filler panel and pulling the panel
out of the server, as shown in the following illustration.
Attention: To maintain proper system cooling, do not operate the server for more
than 10 minutes without either a drive or a filler panel installed in each bay.
4. Install the hard disk drive in the hot-swap bay:
a. Ensure that the tray handle is open (that is, perpendicular to the drive).
b. Align the drive assembly with the guide rails in the bay.
c. Gently push the drive assembly into the bay until the drive stops.
d. Push the tray handle to the closed (locked) position.
e. Check the hard disk drive status LED to verify that the hard disk drive is
operating properly. If the amber hard disk drive status LED for a drive is lit
continuously, that individual drive is faulty and needs to be replaced. If the
green hard disk drive activity LED is flashing, the drive is being accessed.
5. If you have other options to install or remove, do so now; otherwise, go to
“Completing the installation” on page 86.
Note: If the server has a ServeRAID adapter installed, you might need to
reconfigure the disk arrays after installing hard disk drives. See the
documentation for the ServeRAID option for details.
Replacing the diskette drive or CD-ROM drive
Complete the following steps to replace either the diskette drive or the CD-ROM drive:
1. Review the safety precautions beginning on page 53, and “Handling static-
sensitive devices” on page 52.
Filler panel
Drive tray handle
(in open position)
Drive tray
assembly