IBM Eserver xSeries 360 Type 8686, Руководство пользователя

Страница: 114 / 184

100
IBM® xSeries 360: User’s Reference
POST error messages
The following table provides information about the error messages that might appear
during POST.
Note: The operator information panel is also known as the front LED panel.
3-3-2 I
2
C bus has failed. Turn off the server, unplug all
power cords, and reconnect all
power cords; then, restart the
server. If the problem remains,
call for service.
3-3-3 No memory has been detected in the server. Reseat the memory modules or
install a memory module. If the
problem remains, call for service.
Note: In some memory
configurations, the 3-3-3
beep code might sound
during POST followed by
a blank display screen. If
this occurs and the
Boot
Fail Count feature in the
Start Options of the
Configuration/Setup Utility
is set to
Enabled (its
default setting), you must
restart the server three
times to force the system
BIOS code to reset the
memory connector or
bank of connectors from
Disabled to Enabled .
Table 11. POST beep codes.
Table 12. POST error messages.
POST message Description
062 The server failed to start on three consecutive attempts.
All microprocessor caches are disabled. Repeatedly turning the server on
and then off or resetting the server might cause this problem.
Action: Start the Configuration/Setup Utility program and verify that all
settings are correct. Use the
Cache Control selection in the
Advanced Setup menu of the Configuration/Setup Utility program
to enable the microprocessor caches.
If the problem remains, call for service. When the problem is corrected, be
sure to enable the caches.
101
102
106 An error occurred during the system board and microprocessor test.
Action: Call for service.
114 An adapter read-only memory (ROM) error occurred.
Action: Remove the options. If you can start the server without the
options installed, reinstall each option one at a time and retest
after each is reinstalled. When an option fails, replace it.
If you cannot isolate and correct the problem, call for service.
151 A real-time clock (RTC) error occurred.
Action: Call for service.