IBM Eserver xSeries 360 Type 8686, Руководство пользователя

Страница: 100 / 184

86
IBM® xSeries 360: User’s Reference
5. If you have other options to install or remove, do so now; otherwise, go to
“Completing the installation”.
Completing the installation
This section provides the information needed to complete the installation.
Installing the server top cover and bezel
Complete the following steps to install the server top cover and bezel:
1. Before installing the cover, check that all internal cables, adapters, and other
components are installed and seated correctly and that you have not left loose
tools or parts inside the server.
2. Move the cover-release latch to the open (up) position.
3. Insert the tabs on the top cover into the matching slots in the server chassis.
4. Close the cover-release latch to pull the top cover forward and lock the top cover
in place.
5. Insert the tabs on the bottom of the bezel into the matching holes on the server
chassis.
6. Push the top of the bezel toward the server until the two tabs at the top of the
bezel snap into place.
7. If you disconnected any external cables from the back of the server, reconnect the
cables; then, plug the power cords into properly grounded electrical outlets.
Notes:
a. If necessary, see “Input/output ports” on page 87 for connector locations.
b. If you have just plugged the power cords of the server into an electrical outlet,
you must wait approximately 30 seconds before pressing the power-control
button.
Updating the server configuration
When you start the server for the first time after you add or remove an internal option
or an external SCSI device, you might see a message telling you that the
Top cover
Cover release latch
Bezel
Level 2 diagnostic panel