IBM Eserver xSeries 360 Type 8686, Руководство пользователя

Страница: 78 / 184

64
IBM® xSeries 360: User’s Reference
DASD Hard disk drive failure
Out of Spec Power supplies being overdriven
PS2 Power supply number 2 failure
Remind button Remind to invoke remind mode
PS1 Power supply number 1 failure
PS3 Power supply number 3 failure
Non Redund Nonredundant power mode
CPU Microprocessor failure
MEM Memory failure
FAN Fan failure
SP Bus Remote Supervisor Adapter failure
See Log See event log or Remote Supervisor Adapter log
for non-optimal condition information
Notes:
1. The server supports six replaceable voltage regulator modules (VRMs).
2. The server supports a maximum of three power supplies.
3. See “Level 2 Light Path Troubleshooting” on page 125 for a detailed description of
these LEDs and how to use them to resolve problems.
Remind button
You can use the Remind button to place the Fault light on the front panel into the
remind mode (blinks every 2 seconds). By pressing the button, you acknowledge the
failure but indicate that you are not taking immediate action. If a new failure occurs,
the Fault light turns on again.
The Fault light stays in remind mode until one of the following conditions occurs:
• All known problems are resolved
• The system is restarted
• A new problem occurs
You can use the Remind button to delay server maintenance until a later time.
However, if the light is still blinking from an error condition, it is unable to indicate a
subsequent error. Resetting the Fault light by resolving the problem enables the light
to indicate a subsequent error.
The following illustration shows the location of the LEDs on the system board. You
might need to refer to this illustration when solving problems with the server.
Note: The illustrations in this document might differ slightly from your hardware.