IBM Eserver xSeries 360 Type 8686, Руководство пользователя

Страница: 119 / 184

Chapter 6. Solving Problems
105
11 xx An error occurred during the system-board serial port test.
Action: If you have a modem, serial printer, or other serial device
attached to the server, verify that the serial cable is connected
correctly. If it is, use the following procedure:
1. Turn off the server.
2. Disconnect the serial cable from the serial port.
3. Wait 5 seconds; then, turn on the server.
If the POST error message does not reappear, either the serial cable or
the device is probably failing. See the documentation that comes with the
serial device for additional testing information.
If the POST error message reappears, call for service.
1162 The serial port configuration conflicts with another device in the system.
Action: 1. Make sure the IRQ and I/O port assignments needed by the
serial port are available.
2. If all interrupts are being used by adapters, you might need
to remove an adapter to make an interrupt available to the
serial port, or force other adapters to share an interrupt.
1301 Cable to the operator information panel not detected.
Action: Make sure that the cable to the operator information panel card is
connected.
If the problem remains, call for service.
1302 Cable to SCSI Backplane not detected.
Action: Make sure that the cable between the Level 2 Light Path card and
the SCSI hard drive back plane is connected.
If the problem remains, call for service.
1303 Cable to Hotplug Switch not detected.
Action: Make sure that the cable between the PCI switch card and the
system board (J36) is connected.
If the problem remains, call for service.
1304 Cable to Media not detected.
Action: Make sure that the cable between the media interposer card and
the Level 2 Light Path card is connected.
If the problem remains, call for service.
1600 The Remote Supervisor Adapter is not functioning.
Action: 1. Verify that the jumpers for the Remote Supervisor Adapter
are set correctly.
2. Disconnect the server from all electrical sources, wait for 30
seconds, reconnect the server to the electrical sources, and
restart the server.
If the problem remains, call for service.
1162 The serial port configuration conflicts with another device in the server.
Start the Configuration/Setup Utility program and ensure that the IRQ and
I/O port assignments needed by the serial port are available.
Table 12. POST error messages.
POST message Description