IBM Eserver xSeries 360 Type 8686, Руководство пользователя

Страница: 83 / 184

Chapter 5. Installing options
69
“Replacing the Remote Supervisor Adapter” on page 70; otherwise, continue with
the following instructions.
Complete the following steps to install a hot-plug PCI/PCI-X adapter:
1. Review the safety precautions beginning on page 53, “Handling static-sensitive
devices” on page 52, and “Working inside the server with the power on” on page
52.
2. Remove the top cover (see “Removing the server top cover and bezel” on page
66) and determine which PCI-X expansion slot you will use for the adapter.
Note: All six PCI-X slots support hot-plug PCI/PCI-X adapters.
3. Slide the orange adapter-retention tab toward the rear of the server and lift the
adapter-retention latch. The power LED turns off for the appropriate slot.
4. Slide the expansion-slot cover up and out of the server; then move the blue PCI-
adapter locking lever to the right (as viewed from the front) to enable insertion of
the new adapter.
Attention: Avoid touching the components and gold-edge connectors on the
adapter. Ensure that the adapter is completely and correctly seated in the slot.
Incomplete insertion might cause damage to the system board or the adapter.
Attention: When you handle Electrostatic Discharge-Sensitive devices (ESD),
take precautions to avoid damage from static electricity. For details on handling
these devices, see “Handling static-sensitive devices” on page 52.
5. Remove the adapter from the static-protective package and install the adapter,
pressing it
firmly into the slot.
6. Move the blue PCI-adapter locking lever to the left (as viewed from the front) to
secure the adapter; then, lower the adapter-retention latch over the top corner of
the adapter. The orange adapter-retention tab snaps into place and the power
LED turns on for the slot.
7. Connect any needed cables to the adapter.
Unlock
Lock
Adapter locking lever
Adapter
retention
latch
Adapter
retention
tab
Adapter
Attention
LED
Power
LED