IBM Eserver xSeries 360 Type 8686, Руководство пользователя

Страница: 121 / 184

Chapter 6. Solving Problems
107
8603 An error occurred during the mouse (pointing device) controller test. The
addition or removal of a mouse, or a failing system board can cause this
error.
Note: This error also can occur if electrical power was lost for a very brief
period and then restored. In this case, turn off the server for at
least 30 seconds; then, turn it back on.
Action: Ensure that the keyboard and mouse (pointing device) are
attached to the correct connectors. If they are connected
correctly, use the following procedure:
1. Turn off the server.
2. Disconnect the mouse from the server.
3. Turn on the server.
If the POST error message does not reappear, the mouse is probably
failing. See the documentation that comes with the mouse for additional
testing information. If the problem remains, replace the mouse or pointing
device.
If the POST error message reappears, run the diagnostic tests to isolate
the problem. If the diagnostic tests do not find a problem and the POST
error message remains, call for service.
00012000 Microprocessor machine check.
Action: 1. Update the system BIOS.
2. If the problem remains, replace the microprocessor.
0001950 x Microprocessor x is not functioning.
Action: Replace microprocessor x .
(The microprocessor x error light will be on.)
If the problem remains, call for service.
0001970 x Microprocessor x failed the built-in self test.
Action: Replace microprocessor x .
(The microprocessor x error light will be on.)
If the problem remains, call for service.
Table 12. POST error messages.
POST message Description