IBM eServer xSeries 345 Type 8670, Руководство по обслуживанию

Страница: 65 / 176

Attention: When you install an adapter in the server, be sure that it is
completely and correctly seated in the connector. Incomplete insertion
might cause damage to the system board or the adapter.
Adapter
retainer
PCI adapter
9. If you removed the PCI riser-card assembly to install the adapter, press the
PCI riser-card assembly firmly into the connector and tighten the two captive
screws.
Note: Make sure that the PCI riser-card assembly is properly seated on the
system-board connector and that the cables under the PCI riser-card
assembly are not pinched.
10. Connect any needed cables to the adapter. See the documentation that comes
with your adapter for cabling instructions.
Attention:
v
When you route the cables, do not block the ventilated space around any of
the fans. In addition, route any cables that are plugged into the PCI adapter
under adjacent adapters so they are not pinched between the top edge of
the adapter and the shuttle side wall.
v To ensure system reliability, an optional SCSI adapter cannot control internal
hard disk drives.
11. If you have other options to install or remove, do so now; otherwise, go to
“Installing the server cover and bezel” on page 71.
PCI riser card removal
To remove and install the PCI riser-card assembly, refer to the following
instructions.
Chapter 4. Customer replaceable units
55