IBM 6219 - IntelliStation M - Pro, Руководство по конфигурации и настройкам

Страница: 110 / 317

86
2109F16 SAN Fibre Channel Switch, 16-Port - - - - - -
2108R3L SAN Data Gateway Router Ultra SCSI LVD Port
10
- - - - - -
Networking
11
Ethernet
12
06P3601 10/100 Ethernet Server Adapter
13
Half 32-bit 1 ... 6 X Universal 33
09N9901 10/100 EtherLink Server Adapter by 3Com
14
Half 32-bit 1 ... 6 X Universal 33
22P4901 10/100 Dual Port Server Adapter
13
Half 64-bit 1 ... 6 X Universal 66
22P6801
PRO/1000XT Server Adapter by Intel (copper) w/CD,
manuals
13
Half 64-bit 1 ... 6 X Universal 133
22P7801 NetXtreme 1000 SX Fiber Ethernet Adapter Half 64-bit 1 ... 6 X Universal 133
31P6301 NetXtreme 1000 T Ethernet Adapter (copper)
13
Half 64-bit 1 ... 6 X Universal 133
Token Ring
34L5201
High-Speed 100/16/4 Token-Ring PCI Management
Adapter
Half 32-bit 1 ... 6 X Universal 33
34L5001 16/4 Token-Ring PCI Management Adapter
13
Half 32-bit 1 ... 6 X Universal 33
Communications
15
19K4162 V.90 PCI Data/Fax WinModem (Low Profile Enabled)
16
Half 32-bit 1 ... 6 - Universal 33
33L4618 V.90 PCI Data/Fax Modem
16
Half 32-bit 1 - 5 33
37L14xx Serial I/O SST 8- and 16-port adapters
17
Half 32-bit 1 - 5 33
System Management
09N7585 Remote Supervisor Adapter
18
Half 32-bit 1 - Universal 33
Note: xSeries 235 supports the IXA Adapter (P/N 1519100) for connection to iSeries models for Windows 2000 Server and Advanced Server. Installation is restricted to slot four and Remote
Supervisor Adapter (P/N 09N7585) must be installed.
1. A 64-bit adapter installed into a 32-bit slot will transfer data at 32-bit rates. Adapters rated at 66MHz will operate at 33MHz when installed in a 33MHz slot. 33MHz adapters will reduce
66MHz buses to 33MHz. 133MHz PCI-X adapters are backward compatible with 33/66MHz, 64-bit PCI-based servers.
2. Slots five and six (bus 2) are hot-plug capable. For Network Operating System support, access www.pc.ibm.com/us/compat.
3. xSeries 235 includes a dual-channel Ultra320 SCSI controller with two internal connectors. An external 0.8mm VHDCI connector can be enabled using optional External SCSI Interface
Kit (P/N 32P8164) to connect channel A to the external connector. External connection using this option and the external knockout is not supported if both channels of the integrated
controller are connected internally, in which case a supported PCI SCSI controller is required to support an external SCSI device. See “Internal SCSI Cabling” for cabling alternatives.
4. ServeRAID-4H Ultra160 SCSI Controller is powered by a 266MHz PowerPC 750 processor and provides 128MB of battery-backed ECC cache with two internal and four external Ultra160
connectors (a combination of four connectors may be utilized). External connectors are 0.8mm VHDCI. Connection of this adapter to the HDD backplane requires optional Single-drop
Internal LVD Ultra160 SCSI Cable (P/N 71P8995), which is a 30in single-drop round nonterminated LVD SCSI cable.
5. ServeRAID-4Mx Ultra160 SCSI Controller is powered by a 100MHz Intel Zion GC80303 processor that provides 64MB of battery-backed ECC cache and two internal and two external
Ultra160 connections (only two connectors may be used). External connections are 0.8mm VHDCI. Connection of this adapter to the HDD backplane requires optional Single-drop Internal
LVD Ultra160 SCSI Cable (P/N 71P8995), which is a 30in single-drop nonterminated LVD SCSI cable.
6. ServeRAID-4Lx Ultra160 SCSI Controller is powered by a 100MHz Intel Zion GC80303 processor and provides a single channel, 32MB of ECC cache and either one internal or one
external Ultra160 connection. External connector is 0.8mm VHDCI. Connection of this adapter to the HDD backplane requires optional Single-drop Internal LVD Ultra160 SCSI Cable
(P/N 71P8995), which is a 30in single-drop round nonterminated LVD SCSI cable.
7. PCI Wide Ultra160 SCSI Adapter (P/N 19K4646) provides a single channel with one internal connector, a five-drop multi-mode terminated LVD SCSI cable and one external 0.8mm VHDCI
connector. Only one of the two connectors may be utilized.
8. ServeRAID-5i (P/N 25P3492) supports both Ultra320 and Ultra160 HDDs in a dedicated or mixed environment. The adapter installs into PCI slot four and converts both channels of the
onboard SCSI controller to RAID in conjunction with the LSI 1020/30 chipset. Both the standard and the optional SCSI HDD backplanes cable directly to the onboard controller connectors.
Half-high tape drives can be supported either internally or externally on the second channel of an integrated controller managed by ServeRAID-5i if the bus is designated as SCSI during
RAID setup. Supports up to 528MB/s data transfers across the PCI bus with 128MB ECC SDRAM write-back cache with battery backup. Supports RAID levels 0, 1, 10, 5, 50 and 1E.
9. See Fibre Channel Solutions Overview section for additional configuration information.
10.The 2108R3L SAN Data Gateway Router Ultra SCSI LVD Port provides one integrated short-wave optical port and two SCSI ports for tape storage connections (LVD, HVD and single-
ended).
11. xSeries 235 includes a copper integrated 10/100/1000Mbps Broadcom (BCM5703) single-port Ethernet controller.
12. In a fault-tolerant networking environment, using the fault-tolerant software delivered with the Ethernet adapters of a single manufacturer is recommended. Installing fault-tolerant
solutions provided by multiple manufacturers may cause failures if the intermediate drivers provided with the adapters are not compatible.Three optional Ethernet adapters are copper and
Intel-based (P/N 06P3601, 22P4901, 22P6801). Two are Broadcom-based (P/N 22P7801, 31P6301).
13. The Wake on LAN (WoL) function provided by this Ethernet PCI adapter is supported in this system.
14. Not supported when greater than 4GB of random access memory (RAM) is installed.
15. xSeries 235 provided three USB ports (two on the rear of the chassis and one on the front), one serial port, two RS-485 ports for system management and one parallel port.
16. Due to homologation variances, modem availability may differ by country.
17. See Appendix E for details on Serial I/O options and configuration limitations.
18. When installed in xSeries 235, Remote Supervisor Adapter (RSA) shares functionality with the integrated service processor and serves as interface for both. RSA provides full system
management functionality through a customer-supplied Ethernet cable or modem connection or as part of an interconnected system management bus (option includes all interconnect
hardware). An external Cat5 connection between RSA and the integrated service processor using the pigtail cable and short Cat5 cable supplied with RSA is not required. The 20-pin
ribbon cable connecting RSA to the planar meets all powering and signaling requirements. Connection of the external AC power supply provided with RSA is not required.