IAI ERC3, Инструкция по эксплуатации

Страница: 92 / 188

Chapter 3 Operation
3.4 Field Network
Address Map
84
3.4.5 Control Signals for Direct Indication Mode
This is an operation mode to indicate directly with values for the target position, positioning
width, speed, acceleration/deceleration and pressing current.
Set a value to each input and output data register. Set to the parameters when using the zone
signals.
The main functions of ERC3 capable to control in this mode are as described in the following
table.
ROBO cylinder function

: Direct control
△
: Indirect control
 : Disabled
Remarks
Home-return operation

Positioning operation

Speed and acceleration/
deceleration setting

Pitch feed (inching)

Pressing operation

Speed change during
movement

Operation at different
acceleration and
deceleration

Pause

Zone signal output
△
Parameters must be set.
PIO pattern selection

(1) PLC Address Composition
(m is PLC input and output top word address for each axis number)
PLC → ERC3 (PLC Output) ERC3 → PLC (PLC Input)
Target Position m to m+1 Current Position m to m+1
Positioning Width m+2 to m+3 Command Current m+2 to m+3
Command Speed m+4 Current Speed m+4
Acceleration/
Deceleration
m+5 Cannot be used. m+5
Pressing Current Limit m+6 Alarm Code m+6
Control Signal m+7 Status Signal m+7
[Refer to Section 3.4.2 for the address maps for each Fieldbus.
Caution : This mode is not applicable for CompoNet, MECHATROLINK and MEC Mode
specifications.
ME0302-4A