Note
This feature is NOT available on i³Remote.
7.
Choose the correct camera make and model (Type) for the PTZ cameras from the list
provided
8.
Check the Auto-Pan (A/P) checkbox for the installed Speed Domes. This feature allows
the speed dome to return to the programmed auto pan after a user adjusts the PTZ
settings remotely and exits the program without returning to the original settings.
9.
Assign Dwell Time for the A/P setting. This is the time that will pass before the Auto-
Pan (A/P) will be activated. In the above example, Camera 1 will return to the original
pan after 20 seconds.
Note
This feature is available on i³Remote under Other setup tab.
Related Topics: PTZ mode | Sensor Setup | External Monitor | Motion Detection | Schedule
Setup | Screen Division | Password Setup
Hardware Setup - Sensor Setup
Overview
In the Sensor Setup the user can configure the connected sensors. Sensors are set as NC or
NO (NC = Normally Closed; NO = Normally Open).
An NC sensor is any sensor with an electrical circuit closed by default.
E.g. - a sensor on a closed door. When the door is opened, the electrical circuit is broken and
the sensor is triggered.
An NO sensor is any sensor with electrical circuit open by default. E.g. - the light in a refrigerator.
The light is off by default. When the refrigerator door is opened the circuit is closed and thus the
sensor is triggered and the light goes on.
Creating/Modifying Sensor Settings
To configure the available sensors, do the following:
1.
Enable all connected sensors
17
i³Server
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at
http://www.renderx.com/
