[
´
1]:
Make the zoom (magnification) 1.0 times.
[+]:
Adjust the zoom (magnification) to the “Tele” side.
IMPORTANT
•
If extra optical zoom is configured after configuring settings for the mask area (
®
®
“3.6.4.4 Configure the settings relating to the privacy zone
(“Privacy zone” setup menu)”), VMD area (
®
“3.8.3 Configure the VMD settings [VMD area]”),
SCD area (
®
“3.8.5 Configure the SCD settings [SCD area]”) and VIQS area
(
®
“3.6.4.6 Configure the VIQS area”), the configured areas for those settings may move out
of alignment. Therefore, perform the setting for extra optical zoom function before other
settings.
[Brightness adjustment] button
Adjust the brightness.
Click the [+] button to make the image brighter.
Click the [-] button to make the image darker.
Click the [Reset] button to reset to the default brightness setting.
[Installation angle of view confirmation]
If you click the [Installation angle of view confirmation] button, an image showing the amount of
deviation from the position when registering the installation angle of view, the pitch direction of the
camera, and the roll direction is displayed in the main area.
It is a guide for returning to the original angle of view if it deviates from the angle of view at the time of
installation.
Correct the angle of view while moving the camera in the pitch and roll directions.
Note
•
Click again to turn off the display in the main area. It will also turn off automatically after it is
displayed for a while.
•
If the deviation from the angle of view when installed is large, the display for the amount of
deviation may not work properly.
[Registering the installation angle of view]
Click [Execute] to save the current position as the “initial installation angle of view”. Click [Delete] to
delete the “initial installation angle of view”.
[Angle of view error lamp]
Set “On” or “Off” whether to notify by using the LED indicator if the deviation from the initial installation
angle of view occurs.
Default:
On
[Close] button
Close the setup menu.
Note
•
When the HTTP port number is changed from “80”, enter “http://IP address: (colon) + port number”
the address box of the browser. When using the DDNS function, access to “http://Host name registered
in the DDNS server: (colon) + port number”
•
When “HTTPS” is selected for “HTTPS” - “Connection” on the [Advanced] tab of the “Network” page,
enter as follows.
“https://IP address: (colon) + port number” or “https://Host name registered in the DDNS server: (colon)
+ port number”
•
When the authentication window is displayed, enter the user name of an administrator or user and
password. Depending on the mobile terminal in use, password entry may be required each time the
screen is switched.
•
Depending on the tablet device in use, larger size images may not be displayed. In this case, selecting
a setting close to the lowest quality setting for “Image quality setting” of “JPEG” (
®
the settings relating to JPEG images [Image]”) may sometimes solve this problem.
22
Operating Instructions
1 Operations
