Refresh Rate
JPEG format image refresh interval setting permissions (
®
selection display button - [Refresh interval] pull-down menu”)
Snap shot
Snap shot operation permissions (
®
Playback of recording (Log
disp.)
Log operation permissions (
®
“Camera control panel - SD memory
Manual rec./Delete rec.
SD memory card save/delete permissions (
®
SD memory card − [Rec. on SD]”)
Brightness
Brightness setting permissions (
®
3.9.2 Configure the settings relating to the host authentication
[Host auth.]
Click the [Host auth.] tab on the “User mng.” page. (
®
“3.2.1 How to display the setup menu”, “3.2.2 How to
operate the setup menu”)
The restriction settings of PCs (IP address) from accessing the camera can be configured on this page.
[Host auth.]
Select “On” or “Off” to determine whether or not to authenticate the host.
•
Default:
Off
Note
•
Set “Host auth.” to “On” after registering the IP address of the PC.
•
If “On” is selected for “User auth.”, the user authentication is required regardless of the host
authentication settings.
[IP address]
Enter the IP address of the PC to be allowed to access the camera. Host name cannot be entered for the IP
address.
Note
•
When “IP address/subnet mask” is entered, it is possible to restrict PCs in each subnet. For example,
when “192.168.0.1/24” is entered and “2. Camera control” is selected for the access level, the PCs
whose IP address is between “192.168.0.1” - “192.168.0.254” can access the camera with the access
level “2. Camera control”.
•
When the IP address already in use is entered and the [Set] button is clicked, the respective host
information will be overwritten.
•
A “Set address” error message is displayed if the IP address of the PC has not been set properly.
Check the set IP address of the PC again.
[Access level]
Select the access level of the host from the following.
1. Administrator/ 2. Camera control/ 3. Live only
Refer to “3.9.1 Configure the settings relating to the user authentication [User auth.]” for further information
about the access level.
•
Default:
3. Live only
Operating Instructions
123
3 Detailed Settings
