Note
•
Even when “50%” or “75%” is set, OSD will be displayed in the standard size (100%) when displaying
640x360, VGA, 320x180 or QVGA images.
[Brightness status display]
Select “On” or “Off” to determine whether or not to display the status of brightness on images displayed on the
“Live” page when adjusting brightness.
•
Default:
On
[Image rotation]
Set whether or not to rotate the image (JPEG, H.265, or H.264).
•
0 °(Off)
: Does not rotate the image.
•
90 °:
Rotates the image by 90 degrees.
•
180 °(Upside-down):
Turns the image upside down.
•
270 °:
Rotates the image by 270 degrees.
•
Default:
0 °(Off)
IMPORTANT
•
The position shifts if the image rotation setting is changed when the following area settings are
configured. Therefore, configure the settings for each area after configuring the image rotation.
–
Privacy zone (
®
“3.6.4.4 Configure the settings relating to the privacy zone (“Privacy zone” setup
–
VMD area (
®
“3.8.3 Configure the VMD settings [VMD area]”)
–
SCD area (
®
“3.8.5 Configure the SCD settings [SCD area]”)
–
VIQS area (
®
“3.6.4.5 Configure the VIQS setting”)
–
Mask area (
®
–
Overlay image (
®
“3.5.5 Configure the overlay image function [Overlay image]”)
•
If “90 °” or “270 °” is selected for “Image rotation”, depending on the “Character size” setting and the
number of characters used, characters displayed on the screen may be cut off.
•
When “90 °” or “270 °” is selected for “Image rotation”, the position selectable with “OSD” - “Position”
is limited to “Upper left” or “Lower left”.
•
When “16:9 mode(30fps mode)” or “16:9 mode(25fps mode)” is selected for “Image capture mode”,
“90 °” and “270 °” will become available to select.
Note
•
When “320x180” is selected for “Image capture size”, the “90 °” or “270 °” cannot be set for [Image
rotation].
[Indicator]
Determine whether or not to use the following indicators. Select “On” to use the following indicators to check
the operational status by lighting them.
–
Link indicator (LINK)
–
Access indicator (ACT)
–
Power indicator
–
Red LED indicator
–
Green LED indicator
•
Default:
On
Note
•
Link indicator (LINK) (orange):
This indicator will light when communication with the connected
device is available.
•
Access indicator (ACT) (green):
This indicator will blink when accessing a network.
66
Operating Instructions
3 Detailed Settings
